⚠ 24/7 Emergency Service · (386) 437-3068
Palmetto Electric Inc. logo
Storm smarts

Whole-Home Surge Protection for Florida Homes, Explained

Florida storms bring lightning and power surges. Learn how whole-home surge protection works with plug-in strips to guard your AC, appliances and electronics.

By Palmetto Electric Inc. · Published October 14, 2026 · Last updated October 14, 2026 · 4 min read

A whole-home surge protector is a device installed at your electrical panel that catches big voltage spikes before they reach the rest of your house. Paired with good plug-in surge strips at your TVs and computers, it is one of the most practical upgrades a Florida homeowner can make, because our summer storms and the switching that happens on the power grid send surges into homes all the time.

Here is what that actually means for your house in Palm Coast, Flagler Beach or anywhere along this stretch of the coast.

What a power surge actually is

A surge is a short burst of voltage much higher than your home is built for. It might last a tiny fraction of a second, but that's long enough to damage the circuit boards inside modern appliances.

Surges come from two places:

  • Outside the house. Lightning strikes nearby, utility equipment switching, downed lines and power coming back on after an outage.
  • Inside the house. Big motors like your AC compressor, pool pump or well pump cycling on and off. These are small surges, but they happen every day and can wear electronics down over time.

People usually think about the lightning strike. The everyday small stuff matters too.

What's at risk

Almost everything in a modern home has a circuit board in it now:

  • AC systems and thermostats
  • Refrigerators, washers, dryers and dishwashers
  • Smart home systems, Wi-Fi gear and security cameras
  • Pool equipment and well pumps
  • Garage door openers
  • TVs, computers and game systems

Replacing even one of those after a storm hurts. Replacing the AC control board in August hurts a lot more.

How whole-home surge protection works

A whole-home surge protective device (often called an SPD) gets installed at or next to your main electrical panel. When voltage jumps above a safe level, it sends the extra energy to ground before it can travel through your branch circuits.

Think of it as the first line of defense. It handles the big incoming surges from the utility side and protects hard-wired equipment that a power strip can't, like your AC, water heater and pool pump.

Why you still want plug-in surge strips

A whole-home unit doesn't replace the surge strips behind your TV and computer. It works with them.

The panel unit knocks down the big stuff. The plug-in strip handles what's left right at the device, plus the small surges created inside the house. For expensive electronics, use both. And remember that a cheap power strip is not the same thing as a surge protector. Look for one that's actually rated for surge protection.

The part people forget: grounding

A surge protector needs a good path to ground to do its job. In older homes, or homes that have had a lot of additions over the years, the grounding and bonding system isn't always what it should be. When we install surge protection, we check the grounding at the same time. A surge protector on a poor ground isn't doing you much good.

Signs it's worth doing now

Whole-home surge protection makes a lot of sense if:

  1. You've lost an appliance or electronics after a storm before.
  2. You have a lot of smart home gear, a home office or a Control4 system.
  3. You have a pool, well pump or other big motor loads.
  4. Your home is in an area that sees a lot of lightning (which, in Florida, is most of us).
  5. You're already having panel work done, like an upgrade or a generator hookup.

Surge protection and generators

If you have, or are planning, a standby generator, talk to us about surge protection at the same time. Power coming back on after an outage is a classic surge moment, and the transfer between utility and generator power is a good time to have the house protected.

What we recommend

Every house is different, so we'll look at your panel, your grounding and what you're trying to protect before we recommend anything. We don't guess at pricing over the phone, but we're happy to come take a look.

Call Palmetto Electric at (386) 437-3068. We're a licensed, family-owned electrical contractor and we've been protecting Northeast Florida homes since 1985.

Frequently asked questions

Does a whole-home surge protector stop a direct lightning strike?

No device can promise protection from a direct strike. A whole-home surge protector is designed to reduce the damage from the much more common surges caused by nearby strikes and utility switching.

Do I still need surge strips if I have whole-home protection?

Yes. The panel unit handles the big incoming surges and protects hard-wired equipment. Plug-in surge strips add a second layer right at your TVs, computers and other sensitive electronics.

Can I install a whole-home surge protector myself?

It gets installed inside or at your electrical panel, which has live parts even with the main breaker off. It should be installed by a licensed electrician who also checks your grounding.

Got a question about your wiring?

Call the family-owned crew that has been doing this in Northeast Florida since 1985. Honest answers, licensed electricians, no runaround.